GNEE through the study of 8011 aluminium foil intermediate annealing process on the performance of aluminium foil, found that its mechanical properties fluctuation is large, specifically manifested as tensile strength fluctuations in the range of 66 ~ 110MPa, elongation in the range of 2% fluctuation, in order to change the status quo, they are through the optimization of the intermediate annealing process to reduce the fluctuation of elongation, and at the same time reduce the elongation, in order to increase the tensile strength of the material.
8011 Aluminum Foil Technical Parameter
| Ingredient | Si | Fe | Cu | Mn | Mg | Cr | Zn | Ti | Other | Al |
| Content | 0.5-0.9 | 0.6-1 | 0.1 | 0.2 | 0.05 | 0.05 | 0.1 | 0.08 | 0.15 | Margin |
| Alloy Type | 8011 aluminium foil | |||||||||
| Alloy State | F, O, H14, H16, H18, H19, H22, H24, H26, H28 | |||||||||
| Thickness (mm) | 0.014-0.2 | |||||||||
| Width (mm) | 100-1600 | |||||||||
| Length | Jumbo roll | |||||||||
Chemical Component:
| Chemical Component | Content(%) |
|---|---|
| Aluminum (Al) | 97.5~99.1 |
| Iron (Fe) | 0.60~1.0 |
| Silicon (Si) | 0.50~0.90 |
| Copper (Cu) | 0~0.1 |
| Manganese (Mn) | 0~0.1 |
| Magnesium (Mg) | 0~0.1 |
| Zinc (Zn) | 0~0.1 |
| Chromium (Cr) | 0~0.1 |
| Titanium (Ti) | 0~0.05 |
| Residuals | 0~0.15 |
GNEE has improved the tensile strength of 8011 aluminium by adopting an intermediate annealing process of 320°C and a cold rolling processing rate compatible with it, so that the tensile strength reaches 145~185 MPa and elongation >1%, which promotes the development of the 8011 aluminium alloy material.



