GNEE Aluminum for aluminum foil roll packaging requirements
First, the aluminum foil rolls should be wound loosely and tightly, with flat and clean ends and smooth edges.
Secondly, the mislayer of aluminum foil roll shall not exceed ±1.0mm.
|
Product name |
Aluminum foil/coil |
|||
|
Material |
1050,1060,1070,1100,1235,3003,3004,5052,8006,8011,8021,8079,etc |
|||
|
Standard |
|
|||
|
Thickness |
0.006mm(6micron) - 0.2mm (200micron) |
|||
|
Width |
10- 1500 mm (tolerance:± 1.0mm) |
|||
|
Temper |
O,F, H12, 114,H18,H22, H24,H26,H32, etc |
|||
|
MOQ |
1 ton |
|||
Third, the width of the core of the aluminum foil roll is greater than or equal to the width of the foil, and the length of the two ends of the core should not exceed the width of the foil by more than 5mm; Fourth, the aluminum foil roll should be wrapped around the foil.
Fourth, the aluminum foil should be wound in the center of the core.
Fifth, the joint part has a clear joint mark at the two ends of the aluminum coil.
