Testing standards for medicinal aluminum foil composite films

Apr 24, 2025

Leave a message

1. Appearance: Pharmaceutical aluminum foil should be inspected visually in bright natural light. Aluminum foil packets shall not have defects such as perforation, foreign matter, odor, adhesion, separation between composite layers, obvious damage, bubbles, wrinkles, dirt, etc. The heat-sealed part of the aluminum foil composite bag should be flat and without empty seal.

2. Pinhole degree: Take 10 pieces of aluminum foil composite packaging samples with a length of 400mm and a width of 250mm (when the width is less than 250mm, take the roll width), place them one by one on the pinhole detection table, and check their pinholes in the dark. Aluminum foil packaging medicine should not have dense, continuous, or periodic pinholes; there shall be no pinholes with a diameter greater than 0.3mm in each square meter; the number of pinholes with a diameter of 0.1mm to 0.3mm shall not exceed 1.

3. Barrier performance: The water vapor permeability of waterproof aluminum foil is determined according to the relevant determination method. During the test, the heat-sealed surface is facing the low humidity side, and it shall not exceed 0.5g/(m²·24h). The oxygen permeability shall not exceed 0.5cm³/(m²·24h) under the conditions of test temperature of 38℃±2℃ and relative humidity of 90%±5%.
4. Heat-sealing strength of adhesive layer: Take 2 pieces of this product of 100mm×100mm, or 100mm×100mm polyvinyl chloride/polyvinylidene chloride solid pharmaceutical composite aluminum foil hard sheet, and heat-seal at 155℃±5℃, pressure of 0.2MPa, and time of 1 second. According to the heat-seal strength determination method, peel at 180° with a tensile machine, and the speed is 200mm/min±20mm/min. The heat-seal strength shall not be less than 7.0N/15mm (PVC) and 6.0N/15mm (PVDC).

5. Adhesion of protective layer: Take a 90mm long and full-width medicinal aluminum foil sample, place it flat on a glass plate with the protective layer facing up, take a piece of polyester adhesive tape, press it evenly on the surface of the sample horizontally, peel it off at a suitable speed in the direction of 160°~180°, and there should be no obvious shedding of the protective layer on the surface.

6. Heat resistance of protective layer: Take 3 pieces of this product with a size of 100mm×100mm and heat seal them. The heat sealing conditions are temperature 200℃, pressure 0.2MPa, time 1 second, cool to room temperature, and there is no obvious adhesion and shedding of the heat-sealed aluminum foil protective layer after separation.

7. Rupture strength: Take 3 pieces of 40mm×40mm aluminum foil pharmaceutical packaging samples, place them on the rupture strength meter for measurement, and they shall not be less than 98kPa.

8. Fluorescent substance: The adhesive layer and protective layer should not have sheet-like fluorescence at wavelengths of 254nm and 365nm.

aluminum foil packaging medicinelaminated aluminium foil packaging