‌Optimal number of aluminum plate stacking layers

Apr 10, 2025

Leave a message

1. General range of layers ‌
‌Conventional aluminum plates‌:
The recommended stacking layers are controlled at ‌4-6 layers‌, which needs to be adjusted in combination with the thickness, size and storage environment of the aluminum plates.
For example, aluminum plates with a thickness of ≥2.0mm can be appropriately increased to 5-6 layers, and thin plates (such as 1.5mm) are recommended not to exceed 4 layers.
‌Special scenario restrictions‌:
The number of stacking layers of composite plates (including aluminum-based composite materials) should not exceed 4 layers to avoid compression and deformation of the bottom layer.
For lightweight plates such as honeycomb aluminum plates, it is recommended not to stack more than 3 layers at a time to prevent the glue layer from failing under pressure.
‌2. Key influencing factors‌ ‌Aluminum plate thickness and strength‌:
Aluminum plates with a thickness of ≥2.5mm (such as aluminum veneers for curtain walls) have strong load-bearing capacity and can support higher layers.
Thin plates (such as 1.5mm indoor ceiling panels) need to reduce the number of layers to avoid bending or surface scratches.
‌Storage conditions requirements‌:
The warehouse floor must be flat and load-bearing. ‌Buffer materials‌ (such as wooden pads, rubber sheets) should be placed between each layer of aluminum plates to disperse the pressure. ‌In a humid environment, the stacking height should be reduced to prevent the bottom layer from getting damp and oxidized. ‌III. Operation specifications and risk avoidance‌ ‌Stacking method‌: ‌Align the aluminum plates of the same specification to avoid misalignment and center of gravity shift. ‌Large-size aluminum plates should be placed vertically first to reduce the risk of distortion in horizontal stacking. ‌Safety inspection‌: ‌Regularly check whether the bottom aluminum plate is deformed, and adjust the number of layers or increase support in time. ‌The stacking state needs to be reorganized after transportation to avoid structural damage caused by pressure during transportation.

‌Optimal number of aluminum plate stacking layers‌Optimal number of aluminum plate stacking layers