Since the reduction of double-zero aluminum foil in four-pass rolling is greatly increased, the corresponding rolling process parameters used are larger, and the probability of pinholes is greatly increased. Therefore, in addition to ensuring the quality of the blanks, special attention should be paid to the following aspects during the production process:

When producing double-zero aluminum foil in four passes, the control of rolling speed and post-tension should be adjusted based on the surface roughness of the roll and the performance of the rolling oil. Especially in the previous pass and finished product pass, whether the rolling speed and post-tension control are appropriate has the greatest impact on pinholes. Practice has proved that if the rolling speed is too fast or the post-tension is too high, the number of pinholes will increase significantly. If the rolling speed is too slow or the post-tension is too small, it will affect production efficiency and even cause wrinkles and slits in the aluminum foil. Therefore, the speed and tension must be reasonably controlled. Our process requires that the speed during normal rolling should not be greater than 600m/min, and the post-tension should not be greater than 65N/mm².

The higher the cleanliness of the rolling oil, the better, and the fewer pinholes. Therefore, it is necessary to reasonably prepare the ratio of diatomite and activated clay, clean the filter regularly, and have dedicated personnel to manage it to ensure that the rolling filtration system operates well.
The requirements for the surface roughness of the roll are particularly strict. If the surface roughness of the roll is too high, the rolling speed will be faster, pinholes will increase and the surface brightness will be low. In order to ensure stability and quality, pinholes will be reduced. The roughness parameters required by the process should be guaranteed.
