Mill Finish Aluminum Rod Process Analysis

May 12, 2025

Leave a message

Mill Finish Aluminum Rod refers to an aluminum rod that has been rolled but not anodized or other surface treatments. Its core process focuses on metal forming and basic treatment. The following is a breakdown of the key steps:

1. Melting and Casting Preparation
‌Raw Material Proportion and Melting‌
Put the aluminum ingot and alloy elements such as magnesium and silicon into the melting furnace in proportion, heat it to 700-750℃ to form a uniform aluminum liquid, and remove impurities by degassing and filtering.

‌Continuous Casting‌
The aluminum liquid is injected into the casting machine and cooled to form an aluminum billet (usually 100-300mm in diameter). The use of double-roll continuous casting technology can increase the density of the billet and reduce internal pores.

2. Hot Rolling Forming
‌Preheating Treatment‌
The aluminum billet is heated to 400-500℃ to soften the structure, eliminate casting stress, and facilitate subsequent plastic deformation.

‌Multi-pass rolling‌
Gradually reduce the thickness of the aluminum billet through rough rolling and finishing rolling units:

‌Rough rolling‌: Compress the billet thickness to 2-3 times the target value to eliminate casting defects;
‌Finishing rolling‌: Accurately control the rolling force and temperature to finally obtain an aluminum rod with a smooth surface (tolerance ±0.1mm).
3. Cold processing and shaping
‌Cold rolling straightening‌
Cold rolling the hot-rolled aluminum rod (deformation 5-10%) to improve dimensional accuracy and straightness and eliminate rolling bending.

‌Cutting and trimming‌
Use high-precision sawing equipment to cut the aluminum rod to a standard length (such as 6 meters), and the cut burrs need to be polished to Ra≤3.2μm.

4. Quality control
‌Performance testing‌
Sampling test tensile strength (typical value ≥150MPa), elongation (≥12%) and hardness (HB 40-60) to ensure compliance with ASTM B211 standards.

‌Surface inspection‌
Visually or instrumentally inspect the uniformity of the rolling texture, and remove defects such as scratches and oxidation spots.

5. Packaging, storage and transportation
After the surface of the aluminum rod is coated with anti-rust oil, it is protected by wooden pallets + PE film wrapping to avoid bumps and moisture corrosion during transportation.

‌Process features‌: The original luster of the metal is retained in the rolled state, and it can be directly used for machining or as a substrate for deep processing later.

Mill Finish Aluminum Rod Process Analysisaluminum rod suppliers