Flat Rolled Aluminum Coils: Alloys, Tempers and Applications

Jan 21, 2026

Leave a message

Coils are produced by hot rolling and then cold rolling to final gauge, with intermediate annealing used to control temper and formability. They can be supplied mill finish, painted, embossed or coated depending on the end application.

The grade and temper selection determines strength, corrosion resistance, formability and appearance, so matching those properties to the downstream process is the central purchasing decision.

Common Alloys and Their Behavior

Alloy 1100 is commercially pure aluminum with excellent conductivity and formability, used for signage, closures and general sheet metal work. Alloy 3003 with manganese offers better strength with good formability and is a mainstay of roofing, siding, cookware and heat exchanger applications.

Alloy 5052 brings higher strength and outstanding corrosion resistance, making it the standard for marine, transport and pressure vessel components. Alloy 6061 provides heat-treatable structural strength for applications that need more load capacity than the non-heat-treatable grades.

Temper Designations and Formability

Tempers follow the H system for strain-hardened material: H14 quarter hard, H16 three-quarter hard, H18 full hard, and the H22 to H24 range for material that has been partially annealed after cold rolling. O temper is fully annealed and offers maximum ductility.

Lower tempers form more easily but carry less strength, so coil is often selected by the severity of the forming operation. Roofing and cladding may use H14 or H24, while deep-drawn parts prefer O or H22 to avoid cracking.

Dimensions, Finishes and Coil Handling

Coil is produced from about 0.2 mm to several millimeters in thickness, with widths up to around 2000 mm and coil weights set to suit the customer's handling equipment. Inner diameters and coil weights are specified so that decoilers and presses run efficiently.

Surface options include mill finish, stucco and embossed patterns, painted and coated finishes, and protective film. Correct storage and handling prevent edge damage, moisture staining and transit marks that would spoil downstream cosmetic parts.

Major End Uses

Flat rolled coil feeds the building products industry for roofing, wall cladding, gutters and insulation facing, and the transport industry for trailer panels, van bodies and heat shields. The packaging sector uses coil for containers, closures and foil stock.

Appliance manufacturers use coil for refrigerator liners, washing machine bodies and air conditioner components, while the electrical industry uses it for bus bar and transformer strip. This breadth of demand is why coil specification is usually driven by the forming process first and the service environment second.

Frequently Asked Questions

Q: What tempers are available in aluminum coil?
Coil is supplied in O, H12, H14, H16, H18 and the H22 to H24 partially annealed tempers, with the choice governed by the required strength and forming severity.

Q: Which alloy is best for roofing and cladding?
Alloy 3003 in H14 or H24 temper is widely used for roofing and cladding because it combines good strength with excellent formability and corrosion resistance.

Q: What is 5052 coil used for?
5052 coil is used for marine components, transport panels, pressure vessels and other applications that need higher strength together with excellent corrosion resistance.

Q: How thick can aluminum coil be?
Flat rolled aluminum coil is produced from roughly 0.2 mm up to several millimeters, with widths reaching about 2000 mm depending on the mill and alloy.

Q: Can aluminum coil be painted?
Yes. Coil coating lines apply paint or protective coatings continuously before forming, giving a uniform finish that resists fading and scratching in building and appliance use.