Key Takeaways
- 7075 is an Al-Zn-Mg-Cu alloy (zinc about 5.1-6.1%); 6061 is an Al-Mg-Si alloy whose main additions are magnesium and silicon.
- 7075 is much stronger than 6061 and suits high-load applications; 6061 offers medium strength with better corrosion resistance and weldability.
- 7075 is more expensive and has limited weldability; 6061 is more economical, weldable and extrudable.
- Choose 7075 for maximum strength-to-weight with corrosion protection; choose 6061 for weldable, formable general structural use.
1. Composition Difference
7075 aluminum alloy belongs to the Al-Zn-Mg-Cu (7xxx) family: zinc is its main alloying element, typically about 5.1-6.1%, together with magnesium (2.1-2.9%) and copper (1.2-2.0%). 6061 is an Al-Mg-Si (6xxx) alloy: its main alloying elements are magnesium (0.8-1.2%) and silicon (0.4-0.8%), with a much lower zinc content. This difference in alloying system drives almost every other difference between the two grades.
2. Strength Difference
| Property (typical) | 7075-T6 | 6061-T6 |
|---|---|---|
| Tensile strength | 510-570 MPa | 290-310 MPa |
| Yield strength | 430-505 MPa | 240-276 MPa |
| Elongation | 8-11% | 12-17% |
| Weldability | Poor (high hot-cracking sensitivity) | Good (TIG/MIG) |
| Corrosion resistance | Moderate; SCC-sensitive, needs protection | Good, low maintenance |
7075 is suitable for occasions that need to withstand larger loads and higher stress; 6061, although not as strong, still has medium strength and good corrosion resistance and weldability.
3. Price Difference
7075 is relatively expensive because of its high-strength chemistry (zinc and copper alloying), tighter processing control and lower production volumes. 6061 is more affordable because of lower-cost alloying and wide availability.
4. Practicality Difference
7075 is difficult to weld: the Al-Zn-Mg-Cu system is prone to solidification cracking in fusion welding, and its stress-corrosion-cracking sensitivity means protective coatings or anodizing are normally required in service. It is therefore not preferred as a welded frame material. 6061 welds well and can be extruded into tubes and profiles, so it can be used in many ways to add strength and to reduce weight through thin-wall tube designs.
5. Application Difference
7075 is widely used in aerospace (aircraft structural parts), automobile manufacturing (high-performance parts), shipbuilding and electronic products where maximum strength-to-weight matters. 6061 is widely used in building doors and windows, curtain walls, furniture, sports equipment, bicycles and general structural applications where weldability, formability and corrosion resistance are valued.
Frequently Asked Questions
Q1. Is 7075 stronger than 6061?
Yes - 7075-T6 has about 1.6-1.8 times the yield strength of 6061-T6.
Q2. Can 7075 be welded?
Not easily - fusion welding risks hot cracking; mechanical joining is preferred.
Q3. Which alloy is cheaper?
6061 - its alloying elements and processing are less expensive.
Q4. Which should I choose?
7075 for maximum strength with corrosion protection; 6061 for welded, formed or general structural use.


