Basic characteristics of 2A12 aluminum alloy rod

May 12, 2025

Leave a message

I. Chemical composition and alloy design
2A12 aluminum alloy rods aluminum material performance: copper (3.8~4.9%) and magnesium (1.2~1.8%) are the main strengthening elements, supplemented by manganese (0.3~0.9%) and silicon (≤0.5%), etc., to improve strength through solid solution strengthening and aging precipitation phase (such as CuAl₂).
2A12 aluminum rods impurity control: iron and zinc content are limited to ≤0.5% and ≤0.3% respectively to reduce the negative impact of grain boundary brittleness on mechanical properties.
2. Mechanical properties
Strength characteristics: 2A12 aluminum alloy rod tensile strength ≥400 MPa, yield strength ≥350 MPa, elongation ≥12%, hardness ≥110 HB, comprehensive performance is better than ordinary aluminum alloy;
Dynamic load adaptability: 2A12 aluminum round rod has high fatigue resistance and toughness, can withstand repeated impact loads, and is suitable for aviation frames, missile shells and other scenes.
3. Heat treatment and strengthening mechanism
Solution aging strengthening: 2A12 extruded aluminum flat bar solution temperature 495~505℃ (water-cooled quenching), artificial aging 185~195℃ insulation for 6~12 hours, significantly improving strength and hardness; 2A12 flat bar natural aging after room temperature for 96 hours, the strength tends to be stable, but the stability is lower than artificial aging.
Annealing process: Full annealing (390~430℃/30~120 minutes) reduces hardness and improves cold forming processability.
IV. Physical and process characteristics
Lightweight advantage: 2A12 flat bar has a density of 2.78 g/cm³ and a thermal conductivity of 129~165 W/(m·K). It has both high strength and heat dissipation capacity and is suitable for heat dissipation structural parts;
Processing performance: The annealed state has medium plasticity and the quenched state has good cutting performance. Carbide tools are recommended to reduce tool sticking; Welding requires preheating (such as 180℃/30 minutes) to avoid the risk of intergranular cracks during gas welding/argon arc welding. V. Shortcomings and improvements in corrosion resistance
Corrosion resistance limitations: Due to the high copper content (>3.8%), the corrosion resistance is only 30% of pure aluminum, and 2A12 aluminum alloy is susceptible to salt spray and acid rain corrosion; Surface protection technology: 2A12 anodized aluminum rod can form a 10~20μm aluminum oxide film, and the salt spray test life is ≥500 hours; Coating with a pure aluminum layer (such as 1100 alloy) blocks the contact between the substrate and the corrosive medium and extends the service life. Summary: 2A12 aluminum alloy rod has high strength and lightweight as its core advantages. It achieves comprehensive performance improvement through Cu-Mg synergistic strengthening and aging process, but it needs to rely on surface modification technology to make up for the lack of corrosion resistance. It is widely used in high-load scenarios such as aviation and military industry. Processing and welding need to match specific pretreatment processes to avoid defect risks.

2A12 extruded aluminum flat bar

2A12 aluminum flat bar