Basic knowledge of aluminum foil
1. Definition of aluminum foil
Aluminum foil is a roll of aluminum and aluminum alloy strips after rolling process. It is extremely thin and is usually called aluminum coil, strip or sheet.
2. Classification of aluminum foil
According to the shape, aluminum foil can be divided into roll and sheet, among which roll is the most common supply method.
According to thickness, aluminum foil includes thick foil (0.1-0.2 mm), single zero foil (thickness 0.01 mm and less than 0.1 mm) and double zero foil (thickness in millimeters with two zeros after the decimal point).
According to the state, aluminum foil has full hard state, soft state, semi-hard state, quarter hard state and three-quarter hard state.
According to the surface state, aluminum foil can be divided into single-sided light and double-sided light.
According to the use, aluminum foil is widely used in packaging, daily necessities, electrical equipment and construction and other fields.
3. Properties of aluminum foil:
It has the characteristics of lightness, high specific strength, good gloss, high thermal and electrical conductivity, excellent moisture resistance, and non-toxic and odorless. In addition, aluminum foil also has good light-shielding, heat insulation and corrosion resistance.
4. Technical requirements for aluminum foil blanks
It covers many aspects, including melt quality, surface quality, end face quality, as well as skin thickness and width deviation, plate quality, mechanical properties, etc. These requirements ensure the quality and performance of aluminum foil blanks and lay the foundation for subsequent rolling processes.
5. When formulating the aluminum foil rolling process, two key principles need to be followed.
The first is to determine the total processing rate, which reflects the overall deformation degree of the foil from recrystallization annealing to finished product rolling. The second is to determine the pass processing rate, which is the core link in the rolling process. The pass processing rate of pure aluminum series products can reach 65%, but in the first pass after the billet is annealed, excessive processing rate should be avoided, usually controlled at around 50%.


