1. What are the key differences between 7050 and 7075 aluminium alloys for laser cutting?
Both 7050 and 7075 are high-strength aluminium alloys, but 7075 is more widely used due to its superior fatigue resistance and machinability. 7050, however, offers better stress-corrosion cracking resistance, making it suitable for aerospace applications. Laser cutting both alloys requires precise control to avoid heat-affected zone (HAZ) distortions. 7075 tends to produce cleaner cuts with minimal dross, while 7050 may require slower cutting speeds to prevent cracking. The choice depends on the project's mechanical and environmental demands.
2. What laser parameters optimize cutting quality for 7075 aluminium sheets?
For 7075 sheets, a fiber laser with 1–6 kW power and nitrogen assist gas is ideal to reduce oxidation. A focal spot size of 0.1–0.3 mm ensures precision, while cutting speeds of 2–10 m/min balance efficiency and edge quality. Pulse frequency should be adjusted to minimize thermal stress, typically 50–500 Hz. Post-cut deburring is often needed to smooth micro-cracks. These settings mitigate the alloy's high copper content, which can complicate cutting.
3. How does thickness affect laser cutting of 7050 aluminium?
Thicker 7050 sheets (e.g., >6mm) require higher laser power (≥4 kW) and slower speeds to penetrate fully without excessive slag. Thin sheets (<3mm) can be cut at 8–15 m/min but risk warping if heat input isn't controlled. Edge roughness increases with thickness due to prolonged melt ejection. Preheating may help for sheets >10mm to reduce stress. Always use auxiliary gas (argon or nitrogen) to protect the cut surface.
4. What are the common defects in laser-cut 7050/7075 sheets, and how to prevent them?
Common defects include dross, HAZ microcracks, and kerf taper. Dross forms if gas pressure is too low; increasing nitrogen flow to 15–20 bar can help. Microcracks arise from rapid cooling-annealing pre-treatment reduces this risk. Kerf taper (uneven cut width) is corrected by optimizing focal length and nozzle alignment. Regular lens cleaning and beam alignment checks are critical for consistency.
5. Why choose laser cutting over other methods for 7075 aluminium?
Laser cutting excels in precision, especially for complex geometries in 7075's hard-to-machine alloy. It avoids tool wear common in mechanical cutting and produces narrower kerfs than plasma. Unlike waterjet, it doesn't introduce moisture-induced corrosion risks. Automation compatibility reduces labor costs for high-volume projects. However, initial equipment costs are higher than traditional methods.



